User Manual StarLine wireless transponder keyfob (hereinafter referred to as the keyfob) is designed to control the vehicle security system functions using the secure Bluetooth Smart protocol.  The keyfob has 2 built-in buttons and LED indicator.  Button 1 arms and Button 2 disarms security system. StarLine wireless transponder keyfob (hereinafter referred to as the keyfob) is designed to control the vehicle security system functions using the secure Bluetooth Smart protocol.  The keyfob has 2 built-in buttons and LED indicator.  Button 1 arms and Button 2 disarms security system.                     Technical specification Radio range Bluetooth 2.4GHz Battery type Li-Ion CR2032 3V Operation range up to 15 m Operation temperature -20 ... + 40 °C Waterproof rating IP54 Dimensions 53 х 29.2 х 9.2 mm Weight 12 gr Connection checkup Push the button shortly once to check keyfob connection status. 2 LED flashes means connection with security system main unit established. 1 flash means disconnected. A flash color corresponds to the current active mode: green – Regular mode, Anti-hijack mode disabled red – Anti-hijack enabled yellow – Service mode enabled Control over security system Duration of a keyfob buttons pressing: short -  press and release button, followed by a LED flash of corresponding current operation mode long - press and hold button until LED flashing. Duration of a long pressing can be of 2 levels: 1 level -  press and hold button followed by 2 flashes of current operating mode and then a long light, during which the button must be released 2 level - press and hold button followed by 2 flashes of current operating mode and a long light, then followed by serial flashes, during which the button must be released. Command Button press sequence Arm Button 1 short press Disarm Button 2 short press Anti-hijack switch On / Off Button 1 long press 1 level Service mode switch On / Off Button 1 long press 2 level Trunk unlock Button 2 long press 1 level Optional functions Additional functions can be set on the buttons using StarLine Master configuration program: Button 1 short press – arm or start / stop engine 1st level long press – Anti-hijack mode control or start / stop engine Button 2 1st level long press – trunk unlock (supported with the main unit firmware version 2.43 and higher). Pairing keyfob to security system The main unit firmware version must be 2.42.2 and above When security systems is disarmed and IGN Off, press the service button 7 times and switch IGN On. Entry to registration mode will be confirmed by 7 LED flashes of the service button and 7 beeps of the main unit built-in buzzer Open keyfob casing, extract the circuit board                   3. Extract battery from the slot on the board 4. Press and hold the button and insert battery back in the slot. LED will light up red 5. Release the button and make sure the LED serial red flashes come up for 10 sec 6. Successful pairing will be confirmed by LED single green flash, service button LED double flashes and double beeps of the main unit built-in buzzer. If keyfob pairing failed then its LED will light up red 7. Repeat items 2 – 5 for remaining tags and keyfobs 8. Switch IGN Off Transponders and smartphones must be all paired in one registration cycle. All previously paired transponders and smartphones will be deleted from memory Keyfob battery discharging is indicated with 3 sounds of the main unit built-in buzzer (or siren) at IGN On. Then battery must be replaced asap REPLACING KEYFOB BATTERY To replace battery open a keyfob casing carefully with a flat metal or plastic item, remove discharged battery from slot. Install a new battery in the slot observing correct polarity (positive side up). Then fix a cover back. Keyfob is ready for operation. Do not dispose the faulty and broken transponder keyfob along with a regular household waste. It must be disposed at a designated electric and electronic appliances collection point