# Recording and changing PIN-to-Drive code

Recording (changing) PIN-to-Drive code:

1. Disarm system if it is armed
    
    ![6.png](https://help.starline.ru/uploads/images/gallery/2023-11/6.png ".changeauthorizationcodefull v2.20.3 > 6.png")
2. Switch ignition Off  
    ![off.png](https://help.starline.ru/uploads/images/gallery/2024-06/off.png ".changeauthorizationcodefull v2.20.3 > 7.png")
3. Send SMS text command REG XXXX to enter Registration mode, where XXXX is emergency disarm code
4. Wait for the reply SMS: "Attention! Registration mode activated"
5. Switch ignition On  
    ![on.png](https://help.starline.ru/uploads/images/gallery/2024-06/on.png ".emergencyfull v2.23.3 > 18.png")
6. Enter new owner authorisation code by a sequence of vehicle's standard buttons pressing with no more than 3 sec push intervals
    
    ![press standard buttons.png](https://help.starline.ru/uploads/images/gallery/2024-06/press-standard-buttons.png ".changeauthorizationcodefull v2.20.3 > 23.png")
    
      
    Every detected button push shall be followed by a single beep

 7. In 3 sec after the full sequence finished system confirms code entry by 2 beeps

 8. Enter the same buttons sequence once again

 9. Correct button sequence repeated will be confirmed with 2 beeps  
 Invalid sequence entry will be followed by 4 beeps,  
 then retry code recording again from step 6

 10. Switch ignition Off to exit Registration mode

 ![off.png](https://help.starline.ru/uploads/images/gallery/2024-06/off.png ".changeauthorizationcodefull v2.20.3 > 7.png")