Recording and changing PIN-to-Drive code

Recording (changing) PIN-to-Drive code: 

 

 

 Disarm system if it is armed 

 

 Switch ignition Off 

   

 

 Send SMS text command REG XXXX to enter Registration mode, where XXXX is emergency disarm code 

 

 Wait for the reply SMS: "Attention! Registration mode activated" 

 

 Switch ignition On 

 

 Enter new owner authorisation code by a sequence of vehicle's standard  buttons pressing with no more than 3 sec push intervals 

 

 Every detected button push shall be followed by a single beep 

 

         7. In 3 sec after the full sequence finished system confirms code entry by 2 beeps 

         8. Enter the same buttons sequence once again 

         9. Correct button sequence repeated will be confirmed with 2 beeps         Invalid sequence entry will be followed by 4 beeps,         then retry code recording again from step 6 

         10. Switch ignition Off to exit Registration mode