Control with wireless tag (transponder)

Wireless tags availability depends on delivery set 

 The included and optional tags are supplied from factory in transport (power saving) mode, i.e. inactive! Pushing a tag button in this mode is indicated by green and red alternating flashes of the built-in LED. To switch it to normal mode push a tag button several times until flashing color turns to green 

 .

 

 

 Connection check 

 Push button once to check tag connection status. 2 LED flashes means connection with security main unit established, 1 flash means disconnected. A flash color corresponds to the current active mode: 

 

 green - regular mode, Anti-hijack is disabled  

 red - Anti-hijack mode is enabled 

 yellow - Service mode is enabled 

 

 Control over security system 

 Duration of a tag button pushing: 

 

 short – push and release button, followed with a flash of corresponding current operation mode 

 long–push and hold button until LED begins flashing 

 

 Duration of long push are of 2 levels: 

 

 

 1 level – push and hold a tag button followed with double short flashes of current operating mode and then long flash at which button must be released 

 

 

 2 level – push and hold a tag button followed with double short flashes of current operating mode, then one long flash  and then followed with serial flashes at which button must be released 

 

 

 

 

 

 

 

 

 Command 

 

 

 Button push 

 

 

 

 

 

 Arm and Disarm 

 1 short 

 

 

 

 Enable and disable Anti-hijack by tag away 

 

 

 long 1 level 

 

 

 

 Enable and Disable Service mode 

 

 long 2 level 

 

 

 

 

 

 

 Replacing a tag battery 

 Wireless tag (transponder) is equipped with CR2032 3V battery. 

 Tag battery discharging is indicated with 3 sounds of external buzzer (or siren) at ignition On and owner is notified with text message to his phone number. Then battery must be replaced as soon as possible 

 To replace battery open a tag casing carefully with a flat metal or plastic item, remove discharged battery from slot. Install a new battery in the slot observing correct polarity (positive side up, as shown on picture).  Do not forget remove safety sticker from a new battery. 

 

 

 A smartphone with support of Bluetooth 4.2 and above can also be used as a tag. See Devices registration article to pair a smartphone as a tag.