Emergency disarming

System can be fully disarmed with emergency disarm code, when: 

 

 tag is lost 

 

 tag or remote key battery discharged 

 

 Anti-hijack mode is activated 

 

 

 Emergency disarming with service button 

 

 

 Make sure ignition is switched On 

 

 Push service button or external transceiver button a number of times, equal to the first digit of emergency disarm code       

 

 

 Each digit entry will be confirmed within 3 sec with service button LED flashes in a number equal to a sequence number of corresponding digit entered (1,2, 3 or 4 times) 

 

 

 

 4. Repeat 1...2 steps for remaining digits 

 5. Valid code entry is confirmed with 3 flashes and 3 sounds, system turns disarm 

 If invalid emergency disarm code is entered 3 times, then next entry shall be blocked for 15 min. Each button push in this interval will be indicated with 5 flashes 

 Example of entry the code 5342 

 

 Emergency disarming with SMS text message 

 Send SMS text command  30 XXXX , where ХХХХ — emergency disarm code 

 Changing emergency disarm code with service button (or external transceiver button) 

 

 

 switch system in disarmed mode if it is armed 

 

 

 push service button 4 times 

 

 

 switch ignition On. 4 LED flashes and 4 sounds shall follow 

 

 

 entry into code recording will be confirmed with 2 LED flashes and 2 sounds 

 

 

 If nothing is done withing 5 sec system shall turn Off emergency code recording mode 

 5. switch ignition Off 6. switch ignition On and push service button a number of times equal to a first digit of existing emergency disarm code 7. switch ignition Off. Each digit entry will be confirmed with LED flashes equal to a sequence number of corresponding digit entered (1,2, 3 or 4 times) 8. repeat 6...7 steps for remaining digits 9. valid existing code entry will be confirmed with 2 LED flashes and 2 beep sounds 10. switch ignition On. Push service button a number of times equal to a first digit of a new emergency disarm code 11. switch ignition Off. Each digit entry will be confirmed with LED flashes equal to a sequence number of corresponding digit entered (1, 2, 3 or 4 times) 

 12. repeat 10...12 steps for remaining new code digits 13. new code entry will be confirmed with 2 LED flashes and 2 beep sounds 14. enter a new code once again repeating 10...12 steps 15. new emergency disarm code recording will be confirmed with 2 LED flashes and 2 beep sounds