Перейти к основному контенту

Emergency disarming

System can be fully disarmed with emergency disarm code, when:

  • Tag is lost

  • Tag or remote key battery discharged

  • Anti hijack mode is activated

Emergency disarming with service button

  1. Make sure ignition is switched On.


    on.png
  2. Push service button or external transceiver button a number of times, equal to the first digit of emergency disarm code.
    push x times.png         

  3. Each digit entry will be confirmed within 3 sec with service button LED flashes in a number equal to a sequence number of corresponding digit entered (1,2, 3 or 4 times).

Screen Shot 2025-02-09 at 22.46.35.png

4. Repeat 1...2 steps for remaining digits.

5. Valid code entry is confirmed with 3 flashes and 3 sounds, system turns disarm.

If invalid emergency disarm code is entered 3 times, then next entry shall be blocked for 15 min. Each button push in this interval will be indicated with 5 flashes.

Example of entry the code 5342

Screen Shot 2025-02-09 at 22.50.58.png

Emergency disarming with SMS text message

Send SMS text command  30 XXXX , where ХХХХ — emergency disarm code.

Changing emergency disarm code with service button (or external transceiver button)

  1. Switch system in disarmed mode if it is armed.

  2. Push service button 4 times.

  3. Switch ignition On. 4 LED flashes and 4 sounds shall follow.

  4. Entry into code recording will be confirmed with 2 LED flashes and 2 sounds.

If nothing is done withing 5 sec system shall turn Off emergency code recording mode.

5. Switch ignition Off.
6. Switch ignition On and push service button a number of times equal to a first digit of existing emergency disarm code.
7. Switch ignition Off. Each digit entry will be confirmed with LED flashes equal to a sequence number of corresponding digit entered (1,2, 3 or 4 times).
8. Repeat 6...7 steps for remaining digits.
9. Valid existing code entry will be confirmed with 2 LED flashes and 2 beep sounds.
10. Switch ignition On. Push service button a number of times equal to a first digit of a new emergency disarm code.
11. Switch ignition Off. Each digit entry will be confirmed with LED flashes equal to a sequence number of corresponding digit entered (1, 2, 3 or 4 times).

12. Repeat 10...12 steps for remaining new code digits.
13. A new code entry will be confirmed with 2 LED flashes and 2 beep sounds.
14. Enter a new code once again repeating 10...12 steps.
15. New emergency disarm code recording will be confirmed with 2 LED flashes and 2 beep sounds.

Наверх