Recording and changing PIN-to-Drive code

Recording (changing) PIN-to-Drive code:

1. Disarm system if it is armed

   
   
2. Switch ignition Off
   

    

   
   
3. Send SMS text command REG XXXX to enter Registration mode, where XXXX is emergency disarm code

4. Wait for the reply SMS: "Attention! Registration mode activated"

5. Switch ignition On
   

6. Enter new owner authorisation code by a sequence of vehicle's standard  buttons pressing with no more than 3 sec push intervals

   

   
   Every detected button push shall be followed by a single beep
   

        7. In 3 sec after the full sequence finished system confirms code entry by 2 beeps

        8. Enter the same buttons sequence once again

        9. Correct button sequence repeated will be confirmed with 2 beeps
        Invalid sequence entry will be followed by 4 beeps,
        then retry code recording again from step 6

        10. Switch ignition Off to exit Registration mode