Control with wireless tag (transponder)
The included and optional tags are supplied from factory in transport (power saving) mode, i.e. inactive! Pushing a tag button in this mode is indicated by green and red alternating flashes of the built-in LED. To switch it to normal mode push a tag button several times until flashing color turns to green
Connection check
- green - regular mode, Anti-hijack is disabled
- red - Anti-hijack mode is enabled
- yellow - Service mode is enabled
Control over security system
Duration of a tag button pushing:
- short – push and release button, followed with a flash of corresponding current operation mode
- long–push and hold button until LED begins flashing
Duration of long push are of 2 levels:
-
1 level – push and hold a tag button followed with double short
flashes of current operating mode and then long flash at
which button must be released -
2 level – push and hold a tag button followed with double
short flashes of current operating mode, then one long flash
and then followed with serial flashes at which button must be released
|
Command
|
Button push
|
|---|---|
| Arm and Disarm | 1 short |
|
Enable and disable Anti-hijack by tag away |
long 1 level |
| Enable and Disable Service mode |
long 2 level |
Replacing a tag battery
Wireless tag (transponder) is equipped with CR2032 3V battery.
Tag battery discharging is indicated with 3 sounds of external buzzer (or siren) at ignition On and owner is notified with text message to his phone number. Then battery must be replaced as soon as possible
To replace battery open a tag casing carefully with a flat metal or plastic item, remove discharged battery from slot. Install a new battery in the slot observing correct polarity (positive side up, as shown on picture).
Do not forget remove safety sticker from a new battery.
A smartphone with support of Bluetooth 4.2 and above can also be used as a tag. See Devices registration article to pair a smartphone as a tag.